AS ISO 7134:2021 pdf download – Earth-moving machinery — Graders — Terminology and commercial specifications.
2  Normative references The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 5010, Earth-moving machinery — Rubber-tyred machines — Steering requirements ISO 6746-1, Earth-moving machinery — Definitions of dimensions and codes — Part 1: Base machine ISO 6746-2, Earth-moving machinery — Definitions of dimensions and codes — Part 2: Equipment and attachments ISO 7457, Earth-moving machinery — Determination of turning dimensions of wheeled machines ISO 15550:2002, Internal combustion engines — Determination and method for the measurement of engine power — General requirements
3.2  Masses 3.2.1 operating mass mass of the base machine, equipment specified by the manufacturer, operator (75 kg), full fuel tank and full lubricating, hydraulic and cooling systems 3.2.2 shipping mass mass of the base machine without operator, with full lubricating, hydraulic and cooling systems, 10 % of fuel tank capacity and with or without equipment, cab, canopy and/or operator protective structure, as stated by the manufacturer 3.2.3 cab [canopy] [ROPS] [FOPS] mass mass of cab [canopy] [ROPS (roll-over operator protective structure)] [FOPS (falling-object operator protective structure)] with all components and mountings required to secure it to the base machine 3.3  Performance 3.3.1 net power power obtained on a test bed at the end of the crankshaft or its equivalent, at the corresponding engine speed, with the equipment and auxiliaries listed in ISO 15550:2002, Table 1, column 2, and required in column 3 (fitted for engine net power test) Note 1 to entry: If the power measurement can only be carried out with a mounted gearbox, the losses in the gearbox should be added to the measured power to give the net engine power. [SOURCE: ISO 15550:2002, 3.3.3.1, modified.] 3.3.2 maximum travel speed maximum speed that can be obtained on hard level surfaces in each of the forward and reverse gear ratios available 3.4  Attachments (for dimensions, see Annex B) 3.4.1 scarifier mechanism having teeth for penetrating and loosening to shallow depths materials such as earth, asphalt and gravel roads, and similar surfaces Note 1 to entry: The scarifier may be located on the grader ahead of the front wheels or between front and rear wheels.